Nearly free BAD Lever

Features:
Can be slipped on (potentially more persuasion required)
Can be pushed down to drop bolt. (duh)
Can be pushed up to lock bolt back

Issues:
Mushy Mushy Mushy
ugly

Prerequisites:
Has only been tested on Hoffman lower
Mil-spec bolt release

Printer Settings:
100% infill
exclusive tolerances in cura (only has been tested using this setting but may work fine without it)
Print on flat side

Installation:
Fit may be tight. mallet or something might be necessary (be careful not to crack your lower)
Might be easier to install with upper removed.

Feel free to repost or remix or claim it as your own creation or whatever I don't care. Crediting me would be nice, but do whatever you want. Go crazy.