BTC tips: bc1pw4kecfx8wnzel0n9q7qzwtgz3q2wjptfq9cy4q8susuwn7mefufssfr588
Vice block to clamp a Stribog SP9 into a vice to more easily apply torque to the barrel nuts or muzzle device.

This should fit all models of Stribog but I have only tested on the SP9A3

Print at high infill, many walls/tops/bottoms. You will need to print two pieces of this model.

You will need a long M5 screw (75mm+ is recommended) and an M5 nut to secure one end of the clamp. This is to assist in preventing spreading of the clamp as torque is applied to the Stribog. I was going to design a hinge but that seemed like a lot of work compared to a simple bolt hole.
So basically you throw your unloaded and disassembled upper into this clamp, clamp it into your vice and the un-clamped end gets the bolt to assist in stability of the Stribog. You should be able to still use this with the bolt and charging handle installed, but I do not think it will fit with the lower installed. Definitely not on the short handguard model.
Use at your own risk. I am not responsible for you damaging your Stribog, hurting yourself or anyone else, damage to any property, etc.

LBRY Tags: stribog