2.8K
76
7
751
NECESSARY TO THE SECURITY OF A FREE STATE, THE RIGHT OF THE PEOPLE TO KEEP AND BEAR ARMS, SHALL NOT BE INFRINGED
PRINT A F*CKING GUN ★
PRINT A F*CKING GUN ★
PRINT A F*CKING GUN ★
PRINT A F*CKING GUN ★
RELEASE // printables // printables-170310
Released April 14, 2022, 11:18 AM
Indexed March 29, 2026, 10:01 PM
Updated June 27, 2022, 7:09 AM
1.6MiB
Creative Commons — Attribution — Noncommercial — Share Alike
“
”
Printable version of a dust cover for Magpul AR-15 Pmags
Included a .step file if anyone wants to improve it!
I print with it on its side, 100% infill, concentric walls and infill. I use .2 layer height but I think most any will work. Also use tree supports in Cura.
EDIT: I've had a few failures along layer lines since the part is under tension when installed on the mag. It wastes a lot of filament for the supports, but I've found if you print on a 45° angle with the bottom of the cover facing down, it results in a stronger print. I haven't had any layer line failures with this method yet.
Printables Tags: magazine; dustcover; magpul; pmag
No archive preview for this release