55
2
13
NECESSARY TO THE SECURITY OF A FREE STATE, THE RIGHT OF THE PEOPLE TO KEEP AND BEAR ARMS, SHALL NOT BE INFRINGED
PRINT A F*CKING GUN ★
PRINT A F*CKING GUN ★
PRINT A F*CKING GUN ★
PRINT A F*CKING GUN ★
RELEASE // printables // printables-1011086
Released September 18, 2024, 10:27 AM
Indexed March 29, 2026, 10:00 PM
417.9KiB
Creative Commons — Attribution — Noncommercial — Share Alike
“
”
Simple ring that fits around the top of a 1lb smokeless powder bottle so that they can be stacked on top of each other.
These were printed with standard PLA, 10% Cubic Infill, No Supports, with an 8mm Outer Brim.
Note: Because the base is so narrow (to save print time and material), and the top is proportionally larger, good bed adhesion is a must. I have been successful using just an outer brim, but if you have problems, use both an inner and outer brim and make the brims fairly large.
I am including the step file so that you can resize as needed.
Printables Tags: bottlestand; powder; reloading; stacker
No archive preview for this release