216
8
25
NECESSARY TO THE SECURITY OF A FREE STATE, THE RIGHT OF THE PEOPLE TO KEEP AND BEAR ARMS, SHALL NOT BE INFRINGED
PRINT A F*CKING GUN ★
PRINT A F*CKING GUN ★
PRINT A F*CKING GUN ★
PRINT A F*CKING GUN ★
RELEASE // printables // printables-1486672
Released November 20, 2025, 1:06 PM
Indexed March 28, 2026, 5:20 PM
144.0KiB
Creative Commons — Attribution — Noncommercial
“
”
This is a 3 piece solution to mount a SG GO shot timer to a Tek Lok mount. The 3 pieces connect via 2 M2 screws and thread into nuts. I made the tolerances very tight so you may need to gently persuade the nuts into the spots for them. You will need the following hardware:
2 x M2x12 screws
2 x M2 nuts
Once attached, put your Tek Lok mounting pieces in the opposite direction and attach to the Tek Lok mount. Your SG GO will firmly lock into place but can be easily removed just by pulling in the opposite direction.
11/20/2025 - I added a cover / mount for a magnet. I haven't tested this.
100% infill / 0.12 layer height / PLA+
Printables Tags: timer; uspsa; shootingsports; idpa; teklok; shottimer
No tags
No archive preview for this release