Turret Holder for Load-Master and two Filler Braces

285 4 37

NECESSARY TO THE SECURITY OF A FREE STATE, THE RIGHT OF THE PEOPLE TO KEEP AND BEAR ARMS, SHALL NOT BE INFRINGED

PRINT A F*CKING GUN ★ PRINT A F*CKING GUN ★ PRINT A F*CKING GUN ★ PRINT A F*CKING GUN ★

RELEASE // printables // printables-383467

Printables

Released June 11, 2023, 10:56 PM Indexed March 28, 2026, 10:01 PM 8.4MiB Creative Commons — Attribution — Noncommercial — Share Alike

“

”

This Lee Load-Master turret holder attaches to the large variety of Filler Spool Holder braces eg. https://www.thingiverse.com/thing:4810681. It is styled after red_rider_95's https://www.thingiverse.com/red_rider95 Lee Load-master Turret Holder https://www.thingiverse.com/thing:2854192 design that is uses compression of the layers for prevention of layer separation under load. No supports are need when printed top down. The filler mounts are spaced to be compatible with the IKEA SKADIS pegboard filler braces eg. https://www.thingiverse.com/thing:4810681.and my https://www.printables.com/model/503540-clip-on-filler-brace-for-1-wire-rack-shelf .

Revision History:

6/11/2023 - Added a shellplate holder version.

*Rafts:*

*Supports:*

*Resolution:*

*Infill:*

15% Gyroid

*Notes:*

Rotate the model 180 degrees around the Y axis to print top down as shown in the attached image.

Category: Tool Holders & Boxes

Printables Tags: skadis; skadisikea; cartridgereloading; reloadingtools; thingiverse; reloading; reloadingpress; reloadingdies; ikeaskadis

Reloading Tool

No archive preview for this release

Edit Tags