Use at your own risk.

Special Thanks to JoJoMasterson as they made the original model this was based on. His model was specifically for the HMG Receiver flats.

I made modifications to it so that it only works for the MARCOLMAR receiver flats. I used this to bend my own flat without having to rent the one from MARCOLMAR.

YOU NEED TO MEASURE THE DISTANCE ON BOTH SIDES OF YOUR FLAT BEFORE YOU DO ANY BENDING. These flats are expensive and a mistake is doublely so.

Known issue. The tabs on my flat was not centered on receiver according to my measurements I'm not sure if it was a one-off issue so I left the pin alignment holes centered and used slightly smaller pins to hold the flat in place before I pressed it.

LBRY Tags: cetme l; flat; bending; jig; marcolmar