Remix of Toxic Sandbox Keymod angled foregrip.
https://www.thingiverse.com/thing:2889845

Added lugs to to the grip to hold it in position. Cut away material from center section to reduce print time.

There are two versions:
"Keymod AFG Flat" should fit any keymod handguard
"Keymod AFG Slim Handguard" should fit most slim AR-15 handguards with flats that measure 17mm (0.67in) across or smaller. There are "wings" that wrap up around the handguard. This is one in the thumbnail photo.

I used ohhunt KeyMod Hardware. Always use medium strength threadlocker to keep the screws from shaking loose.
https://www.amazon.com/ohhunt-KeyMod-Screws-Wrench-Sections/dp/B077969ZWF

Print Settings:
Print mounting surface down on the bed.
0.2mm layers
100% fan for bridging, 0% fan for everything else (PETG). If you have a really good cooling duct, you can maybe use less than 100% for bridging.
Use supports everywhere
60% or greater infill
Walls, top, and bottom should be 2.4mm or greater, as appopriate for your line width and layer height.
PETG, or something else temperature and sunlight resistant recommended.

LBRY Tags: keymod; afg; angled foregrip; 3d printing