-P365 XL Chassis nose length
-All Files are individually separated
-All Files are Print Orientation Ready
-All files are stippled, Micro Lines
-XL and Macro Grips(o.g. grips coming soon)
-Safety and No Safety Chassis
-Removed Shroud Geometry
-Five-degree offset on rear Picatinny
-Designed for use with suppressors up to 40mm Outer Diameter
-Direct front sling mount designed for use with Adaptiv Defense Carbine sling, or other thinner slings
-Rear Sling point designed for use with Blue Force Gear U-Loop

Printer Settings:
-IMPORTANT-Bottom Shell Thickness: 6mm
-Print Frame/Chassis upside down
-12 wall loops
-66% gyroid infill
-Tree Supports
-Paint supports on optic mount overhangs, example render provided.
-Take extra care to clear out all support material, and use high-quality filament. FCU snaps in snug

Filament:
-Recommended filament type: PCCF
-Hot/heavy loads or increased back pressure/light recoil spring can snap the rear FCU center pin block
If cracked, the receiver pin will rest on enlarged outer side walls and remain functional, albeit undesirable.
Looking at bringing an extended FCU receiver pin to market to help with those stuck using PLA+

Licensing:
-Creative Commons Non-Commercial, including all directly modified versions thereof
-Editable and Modifiable for personal use
-Commercial licensing rights owned by Iron Saddle Armory

Enjoy and rate accordingly. Posts on r/3d2a & GuncadInex Forum are encouraged.

LBRY Tags: p365; pdw; chassis; xl; sig