This modified follower allows for 10 rounds of 22LR to fit in the standard 8 round magazine of the Beretta Bobcat 20x.

To install:

1. Remove the pin from the existing follower. The pin has a pointed end. You must push the pin out from the side opposite the pointed end. It will take some force, as the flat side of the pin is expanded to hold it in the follower.
2. Using some tool, press the button on the magazine base plate and hold it in as you slide the base plate toward the rounded side of the magazine body. Once the base plate is free of the button, you can remove the tool and slide the base plate the rest of the way off. Be careful to not let the button plate and the spring go flying.
3. Once the base plate is removed, release the spring tension slowly and remove the button plate, spring, and 8rd follower from the magazine body.
4. Assemble the 10rd follower by cleaning out the slot (if needed) and then pressing the flat plate into the slot. The cut corners face away from the slot. Firmly press the two pieces together until fully seated. The bottom edge of the plate should be parallel to the flat bottom edge of the slanted piece.  This will take some force. You can also add CA glue to the slot first if you wish, but it is not needed.
5. Insert the assembled follower into the magazine body. it should only go in one way. Replace the spring and the button plate, and slide the base plate on till it clicks.

The original pin and follower are not reused. Keep them in a safe place.

Files are oriented for printing. Printed in generic PETG with 0.1mm Speed profile, 90% Infill with no supports.

Printed on MK4s with 0.4mmHF default nozzle.

If you have any questions, let me know.

Printables Tags: ammo; magazine; bobcat; 22lr; beretta; berettabobcat; 20x; beretta20x